Reasons Why Gas Water Heaters Automatically Turn Off

1. There are many reasons for the automatic flameout of the gas water heater. It may be because the gas water heater has been used for a long time, and the internal joints are loose. Replace one or tighten it.

2. The reason for the induction needle. Once the induction needle in the gas water heater cannot detect the flame signal, the controller will close the gas circuit. At this time, it is only necessary to place the induction needle correctly or wipe off the stains on the surface of the induction needle.

3. It may be that the igniter is damaged. After ignition, it will burn for a while and then automatically extinguish. At this time, the igniter needs to be replaced.

4. Try replacing the battery when the battery is dead, and adjust the water pressure when the water pressure is low.

5. It may be caused by the strong outdoor wind backflowing from the exhaust port and pressing the flame to not touch the ignition feedback needle. Install the windshield.